5.a.b.c
The triplet a.b.c uniquely identifies the individual physical hardware unit,
and cannot be changed.
The unit ID number is used to identify the physical hardware units within
the configurator interface that is used for configuration of the unit.
A simplified diagram demonstrating the relationship between a wired LAN,
and a linked mesh radio network containing a mesh end unit and mesh
point units, is shown in Figure 5 (page 23).
Figure 5. Cisco Network Addressing
Operating the unit in Mesh Point mode or Mesh End mode
If the Cisco FM4200 Fiber radio transceiver unit is installed as part of a
mesh network architecture, it can be set to operate in either of two
operating modes:
Getting Started
© 2021 Cisco and/or its affiliates. All rights reserved. Page 23 of 189
To Next Page
Loading...
