Plotting and interpreting the wireless links
NOTE
The statistical information refresh period is:
• One second for Fluidity (mobile) networks.
• Six seconds for stationary networks.
To plot and interpret all wireless links in the current network, click the FM-
QUADRO™ link in the upper left part of the settings menu (below).
IMPORTANT
If you are working within a Fluidity Layer-3 network cluster, and
the network cluster has more than one Mesh-end radio, access
FM-QUADRO through the Configurator interface of the
cluster's Primary Mesh-end.
Find the Primary Mesh-end by comparing the Mesh ID values
of the Mesh-end radios. The Primary Mesh-end will have a
numerically lower Mesh ID value than the Secondary Mesh-
end.
If you access the FM-QUADRO interface belonging to the
cluster's Secondary Mesh-end, the network topology view will
be shown, but some statistics and configuration information
may not be available to view.
• A graphical view of the current network topology will be shown. A
typical example is shown below.
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved. Page 86 of 189
To Next Page
Loading...
