Cisco IE-3000-8TC Message Guide

CHAPTER
2-1
Cisco IE 3000 Switch System Message Guide
OL-13020-01
2
Message and Recovery Procedures
This chapter describes the Cisco IE 3000 switch system messages in alphabetical order by facility.
Within each facility, the messages are listed by severity levels 0 to 7: 0 is the highest severity level, and
7 is the lowest severity level. Each message is followed by an explanation and a recommended action.
The messages listed in this chapter do not include the hostname or the date/time stamp designation that
displays only if the software is configured for system log messaging.
The chapter includes these message facilities:
• ACLMGR Messages, page 2-2
• BACKUP_INTERFACE Messages, page 2-6
• CMP Messages, page 2-7
• DHCP_SNOOPING Messages, page 2-8
• DOT1X Messages, page 2-11
• DOT1X_SWITCH Messages, page 2-12
• DTP Messages, page 2-15
• DWL Messages, page 2-17
• EC Messages, page 2-17
• ETHCNTR Messages, page 2-21
• EXPRESS_SETUP Messages, page 2-22
• FLASH_DEVICE Messages, page 2-23
• GBIC_SECURITY Messages, page 2-23
• GBIC_SECURITY_CRYPT Messages, page 2-24
• HARDWARE Messages, page 2-25
• HLFM Messages, page 2-27
• IDBMAN Messages, page 2-28
• IGMP_QUERIER Messages, page 2-31
• IP_DEVICE_TRACKING_HA Messages, page 2-32
• MAC_LIMIT Messages, page 2-32
• MAC_MOVE Messages, page 2-33
• PHY Messages, page 2-33
• PLATFORM Messages, page 2-35

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes