2-7
Cisco IE 3000 Switch System Message Guide
OL-13020-01
Chapter 2 Message and Recovery Procedures
CMP Messages
CMP Messages
This section contains the Cluster Membership Protocol (CMP) messages.
Error Message CMP-4-MEM_CMPIP_ADDR_CONFLICT: Conflict with CMP IP address
[IP_address], Reissuing a new CMP IP address to member [dec]
Explanation The cluster commander found a conflict with the assigned CMP IP address of the
member. A new unique CMP IP address is assigned to the member. [dec] is the member number.
Recommended Action This is only a warning message. The commander has already assigned the
cluster member a new unique address. Clear any open TCP connections on the member by using
clear tcp privileged EXEC command.
Error Message CMP-5-ADD: The Device is added to the cluster (Cluster Name: [chars],
CMDR IP Address [IP_address]).
Explanation The device is added to the cluster. [chars] is the cluster name, and [IP_address] is the
Internet address of the command switch.
Recommended Action No action is required.
Error Message CMP-5-MEMBER_CONFIG_UPDATE: Received member configuration from member
[dec].
Explanation The active or standby command switch received a member configuration. [dec] is the
member number of the sender.
Recommended Action No action is required.
Error Message CMP-5-MGMT_VLAN_CHNG: The management vlan has been changed to [dec].
Explanation The management VLAN has changed. [dec] is the new management VLAN ID.
Recommended Action No action is required.
Error Message CMP-5-NBR_UPD_SIZE_TOO_BIG: Number of neighbors in neighbor update is
[int], maximum number of neighbors allowed in neighbor update is [int].
Explanation The number of cluster neighbors in the clustering neighbor update packet exceeds the
number of neighbors supported by the clustering module. The first [int] is the new number of
neighbors, and the second [int] the maximum number of neighbors.
Recommended Action No action is required.
To Next Page
Loading...
