EasyManuals Logo

Cisco IE-3000-8TC Message Guide

Cisco IE-3000-8TC
98 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
2-15
Cisco IE 3000 Switch System Message Guide
OL-13020-01
Chapter 2 Message and Recovery Procedures
DTP Messages
Error Message DOT1X_SWITCH-5-ERR_VLAN_PROMISC_PORT: Attempt to assign VLAN [dec] to
promiscuous 802.1x port [chars]
Explanation An attempt was made to assign a VLAN to a promiscuous IEEE 802.1x port, which is
not allowed. [dec] is the VLAN, and [chars] is the port.
Recommended Action Change the mode of the port so that it is no longer a promiscuous port, or
change the configuration so that no VLAN is assigned.
Error Message DOT1X_SWITCH-5-ERR_VLAN_RESERVED: Attempt to assign reserved VLAN
[dec] to 802.1x port [chars]
Explanation An attempt was made to assign an invalid VLAN to an IEEE 802.1x port. The VLAN
specified is a reserved VLAN and cannot be assigned to this port. [dec] is the VLAN, and [chars] is
the port.
Recommended Action Update the configuration to not use this VLAN.
Error Message DOT1X_SWITCH-5-ERR_VLAN_ROUTED_PORT: Attempt to assign VLAN [dec] to
routed 802.1x port [chars]
Explanation An attempt was made to assign a VLAN to a routed IEEE 802.1x port, which is not
allowed. [dec] is the VLAN, and [chars] is the port.
Recommended Action Change the mode of the port so that it is no longer a routed port, or change the
configuration so that no VLAN is assigned.
Error Message DOT1X_SWITCH-5-ERR_VLAN_RSPAN: Attempt to assign RSPAN VLAN [dec] to
802.1x port [chars]. 802.1x is incompatible with RSPAN
Explanation An attempt was made to assign a remote SPAN VLAN to an IEEE 802.1x port. Remote
SPAN should not be enabled on a VLAN in which ports are configured with IEEE 802.1x enabled.
[dec] is the VLAN, and [chars] is the port.
Recommended Action Either disable remote SPAN configuration on the VLAN, or disable IEEE
802.1x on all the ports in this VLAN.
DTP Messages
This section contains the Dynamic Trunking Protocol (DTP) messages.
Error Message DTP-4-MEM_UNAVAIL: Memory was not available to perform the trunk
negotiation action.
Explanation The system is unable to negotiate trunks because of a lack of memory.
Recommended Action Reduce other system activity to ease memory demands.

Table of Contents

Other manuals for Cisco IE-3000-8TC

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco IE-3000-8TC and is the answer not in the manual?

Cisco IE-3000-8TC Specifications

General IconGeneral
Switching Capacity16 Gbps
MAC Address Table Size8000
Uplink Ports2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature-40°C to 70°C
MountingDIN rail
Ports8 x Ethernet 10/100Base-TX ports
Jumbo Frame SupportYes

Related product manuals