EasyManuals Logo

Cisco IE-3000-8TC Message Guide

Cisco IE-3000-8TC
98 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #75 background imageLoading...
Page #75 background image
2-61
Cisco IE 3000 Switch System Message Guide
OL-13020-01
Chapter 2 Message and Recovery Procedures
SPANTREE_FAST Messages
SPANTREE_FAST Messages
This section contains the spanning-tree fast-convergence message.
Error Message SPANTREE_FAST-7-PORT_FWD_UPLINK: [chars] [chars] moved to Forwarding
(UplinkFast).
Explanation The listed interface has been selected as the new path to the root switch for the listed
spanning-tree instance. The first [chars] is the spanning-tree instance, and the second [chars] is the
interface.
Recommended Action No action is required.
SPANTREE_VLAN_SW Messages
The section contains the per-VLAN spanning-tree-specific message.
Error Message SPANTREE_VLAN_SW-2-MAX_INSTANCE: Platform limit of [dec] STP instances
exceeded. No instance created for [chars] (port [chars]).
Explanation The number of currently active VLAN spanning-tree instances has reached a
platform-specific limit. No additional VLAN instances will be created until the number of existing
instances drops below the platform limit. [dec] is the spanning-tree instance limit, and the first
[chars] is the smallest VLAN ID of those VLANs that are unable to have spanning-tree instances
created.
Recommended Action Reduce the number of currently active spanning-tree instances by either
disabling some of the currently active spanning-tree instances or deleting the VLANs associated
with them. You must manually enable the spanning trees that could not be created because of limited
instances.
STORM_CONTROL Messages
This section contains the storm control messages.
Error Message STORM_CONTROL-3-FILTERED: A [chars] storm detected on [chars]. A
packet filter action has been applied on the interface.
Explanation The amount of traffic detected on the interface has exceeded the configured threshold
values. The system is filtering the excess traffic. The first [chars] is the traffic type, and the second
[chars] is the interface.
Recommended Action Determine and fix the root cause of the excessive traffic on the interface.

Table of Contents

Other manuals for Cisco IE-3000-8TC

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco IE-3000-8TC and is the answer not in the manual?

Cisco IE-3000-8TC Specifications

General IconGeneral
Switching Capacity16 Gbps
MAC Address Table Size8000
Uplink Ports2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature-40°C to 70°C
MountingDIN rail
Ports8 x Ethernet 10/100Base-TX ports
Jumbo Frame SupportYes

Related product manuals