2-64
Cisco IE 3000 Switch System Message Guide
OL-13020-01
Chapter 2 Message and Recovery Procedures
SW_MACAUTH Messages
Error Message SUPQ-4-RECV_QUEUE_STUCK: Receive queue Stuck for asic [dec] queue
[dec].
Explanation The system has detected that the receiving queue is not being cleared in a reasonable
time. The first [dec] is the ASIC, and the second [dec] is the queue number.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
“Error
Message Traceback Reports” section on page 1-4.
SW_MACAUTH Messages
This section contains the MAC address authentication messages.
Error Message SW_MACAUTH-4-UNAUTH_MAC: Unauthenticated MAC [enet] on port [chars]
Explanation The switch has received an unauthenticated MAC address on the specified port. [enet]
is the unauthenticated MAC address, and [chars] is the port.
Recommended Action No action is required.
Error Message SW_MACAUTH-5-CLEAR_TABLE: MAC Authentication Table Cleared
Explanation The MAC authentication table was cleared.
Recommended Action No action is required.
Error Message SW_MACAUTH-5-MACAUTH_ENADSA: MAC Authentication [chars]
Explanation MAC authentication is enabled or disabled. [chars] is the MAC authentication status,
either enabled or disabled.
Recommended Action No action is required.
Error Message SW_MACAUTH-5-MAC_AUTHENTICATED: MAC [enet] was authenticated
Explanation The switch has received a command to authenticate a MAC address. [enet] is the MAC
address.
Recommended Action No action is required.
To Next Page
Loading...
