2-52
Cisco IE 3000 Switch System Message Guide
OL-13020-01
Chapter 2      Message and Recovery Procedures
RMON Messages
RMON Messages
This section contains the remote network monitoring (RMON) messages.
Error Message  RMON-5-FALLINGTRAP: Falling trap is generated because the value of 
[chars] has fallen below the falling-threshold value [dec].
Explanation  A falling trap has been generated. The value of the specified MIB object has fallen 
below the falling threshold value. [chars] is the MIB object, and [dec] is the threshold value.
Recommended Action  Take appropriate action on the specified MIB object.
Error Message  RMON-5-RISINGTRAP: Rising trap is generated because the value of 
[chars] exceeded the rising-threshold value [dec].
Explanation  A rising trap has been generated. The value of the specified MIB object has exceeded 
the rising threshold value. [chars] is the MIB object, and [dec] is the threshold value.
Recommended Action  Take appropriate action on the specified object.
SPAN Messages 
This section contains the Switched Port Analyzer (SPAN) messages.
Error Message  SPAN-3-MEM_UNAVAIL: Memory was not available to perform the SPAN 
operation. 
Explanation  The system was unable to perform a SPAN operation because of a lack of memory.
Recommended Action  Reduce other system activity to ease the memory demands. 
Error Message  SPAN-3-UNKN_ERR: An internal error occurred during a SPAN operation. 
Explanation  SPAN detected an error in its internal operation.
Recommended Action The error might be transient. Try the SPAN operation again. If a second attempt 
also fails, reload the switch by using the reload privileged EXEC command to complete the 
operation.
Error Message  SPAN-3-UNKN_ERR_PORT: An internal error occurred when configuring SPAN 
on port [chars]. 
Explanation  SPAN detected an error in its internal operation. [chars] is the interface.
Recommended Action  The error might be transient. Try the SPAN operation again. If the second 
attempt also fails, reload the switch by using the reload privileged EXEC command to complete the 
operation.