Cisco IE-3000-8TC Message Guide

2-12
Cisco IE 3000 Switch System Message Guide
OL-13020-01
Chapter 2 Message and Recovery Procedures
DOT1X_SWITCH Messages
Error Message DOT1X-5-SECURITY_VIOLATION: Security violation on interface [chars],
New MAC address [enet] is seen.
Explanation A host on the specified interface is trying to access the network or to authenticate in a
host mode that does not support the number of hosts attached to the interface. This is a security
violation, and the port is put in the error-disabled state.
Recommended Action Ensure that the interface is configured to support the number of attached hosts.
Enter the shutdown interface configuration command and then the no shutdown interface
configuration command to restart the port.
DOT1X_SWITCH Messages
This section contains the IEEE 802.1x messages for switches.
Error Message DOT1X_SWITCH-5-ERR_ADDING_ADDRESS: Unable to add address [enet] on
[chars]
Explanation The client MAC address could not be added to the MAC address table because the
hardware memory is full or the address is a secure address on another port. [enet] is the supplicant
MAC address, and [chars] is the interface. This message might appear if the IEEE 802.1x feature is
enabled.
Recommended Action If the hardware memory is full, remove some of the dynamic MAC addresses.
If the client address is on another port, manually remove it from that port.
Error Message DOT1X_SWITCH-5-ERR_INVALID_PRIMARY_VLAN: Attempt to assign primary
VLAN [dec] to 802.1x port [chars]
Explanation An attempt was made to assign a primary VLAN to an IEEE 802.1x port, which is not
allowed. [dec] is the VLAN, and [chars] is the port.
Recommended Action Update the configuration to use a different VLAN.
Error Message DOT1X_SWITCH-5-ERR_INVALID_SEC_VLAN: Attempt to assign invalid
secondary VLAN [dec] to PVLAN host 802.1x port [chars]
Explanation An attempt was made to assign a nonsecondary VLAN to a private VLAN host IEEE
802.1x port. [dec] is the VLAN, and [chars] is the port.
Recommended Action Change the mode of the port so that it is no longer a private VLAN host port,
or use a valid secondary VLAN.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes