Cisco IE-3000-8TC Message Guide

2-31
Cisco IE 3000 Switch System Message Guide
OL-13020-01
Chapter 2 Message and Recovery Procedures
IGMP_QUERIER Messages
IGMP_QUERIER Messages
This section contains the IGMP querier messages.
Error Message IGMP_QUERIER-4-NO_IP_ADDR_CFG: The IGMP querier cannot send out
General Query messages in VLAN [dec] because there is no IP address configured on
the system.
Explanation You must specify an IP address for the IGMP querier at either the global or per-VLAN
level. [dec] is the VLAN ID.
Recommended Action Configure a source IP address for the IGMP querier.
Error Message IGMP_QUERIER-4-SNOOPING_DISABLED: The IGMP querier is operationally
disabled in VLAN [dec] because IGMP snooping has been disabled in this VLAN.
Explanation IGMP snooping is disabled on this VLAN. Do not enable the IGMP querier when IGMP
snooping is disabled. [dec] is the VLAN IDs.
Recommended Action Confirm that IGMP snooping is enabled both globally and on the VLAN.
Error Message IGMP_QUERIER-6-PIM_DISABLED: The IGMP querier is now operationally
enabled in VLAN [dec] because PIM is no longer enabled on the SVI.
Explanation Protocol-Independent Multicast (PIM) is disabled on the switch virtual interface (SVI),
and the IGMP querier function is now enabled. [dec] is the VLAN ID.
Recommended Action No action is required.
Error Message IGMP_QUERIER-6-SNOOPING_ENABLED: The IGMP querier is now operationally
enabled in VLAN [dec] because IGMP snooping is no longer disabled.
Explanation IGMP snooping was enabled. As a result, the IGMP querier function is now enabled.
[dec] is the VLAN ID.
Recommended Action No action is required.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes