Cisco IE-3000-8TC Message Guide

2-4
Cisco IE 3000 Switch System Message Guide
OL-13020-01
Chapter 2 Message and Recovery Procedures
ACLMGR Messages
Error Message ACLMGR-3-INSERTFAIL: Insert of access-map [chars] #[dec] into [chars]
label [dec] failed.
Explanation The system ran out of CPU memory when trying to merge sections of an access map.
The first [chars] is the map name, and the second [chars] is the direction in which the map was
applied. The first [dec] is the entry number, and the second [dec] is the label number.
Recommended Action Reduce other system activity to ease memory demands. For example, remove
any ACLs that have been defined but are not now used. Use simpler ACLs with fewer access control
entries (ACEs). Use fewer VLANs, and remove any unneeded VLANs from the VLAN database.
Error Message ACLMGR-3-INTTABLE: Not in truth table: VLMAP [dec] RACL [dec] Mcb [dec]
Feat [dec].
Explanation An unrecoverable software error occurred while trying to merge the configured input
features. [dec] are internal action codes.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
running-config user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, open a case
with the TAC, or contact your Cisco technical support representative, and provide the representative
with the gathered information. For more information about these online tools and about contacting
Cisco, see the
“Error Message Traceback Reports” section on page 1-4.
Error Message ACLMGR-3-MAXRECURSION: Too many ([dec]) levels of recursion while
merging ACLs (code [dec]).
Explanation The configuration is too complicated for the platform-specific ACL merge code to
support. The most likely cause is too many separate access lists in a single VLAN map or policy
map. The first [dec] is the number of levels of recursion. The second [dec] is an internal code number
of the merge stage that encountered the problem.
Recommended Action Reduce the number of IP or MAC access lists (considered separately) in any
one VLAN or policy map to fewer than the number of levels reported by this log message.
Error Message ACLMGR-3-MERGEFAIL: [chars] ACL merge error [dec] ([chars]) on [chars]
label [dec].
Explanation The ACL manager was unable to complete the merge of the configured features into a
form suitable for loading into the hardware. Packets potentially affected by this feature will be sent
to the CPU for processing instead. The most likely cause is specifying an ACL that is too large or
too complex for the system. The first [chars] is the ACL-type error (ip or mac), the first [dec] is the
error code, the second [chars] is the message string for the preceding error code, the second [dec] is
the label number, and the third [chars] is either input or output.
Recommended Action Specify a smaller and less complicated configuration.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes