Cisco IE-3000-8TC Message Guide

2-3
Cisco IE 3000 Switch System Message Guide
OL-13020-01
Chapter 2 Message and Recovery Procedures
ACLMGR Messages
Error Message ACLMGR-2-NOVLB: Cannot create memory block for VLAN [dec].
Explanation The ACL manager could not save per-VLAN information needed for its correct
operation. Some per-interface features, such as access groups or VLAN maps, will not be configured
correctly. [dec] is the VLAN ID.
Recommended Action Use a less complicated configuration that requires less memory.
Error Message ACLMGR-2-NOVMR: Cannot create VMR data structures for access list
[chars].
Explanation The ACL manager was unable to allocate the value-mask result (VMR) data structures
needed to describe an ACL in a form that can be loaded into hardware. This error is most likely
caused by lack of available memory. [chars] is the access-list name.
Recommended Action Use a less complicated configuration that requires less memory.
Error Message ACLMGR-3-ACLTCAMFULL: Acl Tcam Full. Drop packets on Output Acl label
[dec] on [chars] [chars].
Explanation There are too many ACLs configured for the platform-specific ACL TCAM table to
support. [dec] is the label number, and [chars] represents the layer. The first [chars] is for Layer 3;
the second for Layer 2. If only one layer of TCAM is full, only one string is displayed, and the other
string is NULL.
Recommended Action Reduce the number of IP or MAC access lists to be applied to interfaces.
Error Message ACLMGR-3-AUGMENTFAIL: Augmenting of access-map [chars] on [chars]
label [dec] failed.
Explanation The system ran out of CPU DRAM when attempting to merge internally required
elements with the configured access maps. The first [chars] is the access-map name, the second
[chars] is the direction in which the map was applied (input or output), and [dec] is the label number.
Recommended Action Reduce other system activity to ease memory demands.
Error Message ACLMGR-3-IECPORTLABELERROR: ACL labels are out-of-sync on interface
[chars], label [dec] is not available on asic [dec].
Explanation An internal software error has occurred. [chars] is the interface name. The first [dec] is
the label associated with the ACL, and the second [dec] is the ASIC number.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
“Error
Message Traceback Reports” section on page 1-4.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes