Cisco IE-3000-8TC - Traceback Reports; GBIC_SECURITY_CRYPT Messages

2-24
Cisco IE 3000 Switch System Message Guide
OL-13020-01
Chapter 2 Message and Recovery Procedures
GBIC_SECURITY_CRYPT Messages
Error Message GBIC_SECURITY-4-EEPROM_SECURITY_ERR: GBIC in [chars] failed security
check.
Explanation The GBIC in the specified port has invalid EEPROM data. [chars] is the port in which
the GBIC is inserted.
Recommended Action Remove the GBIC from the port.
Error Message GBIC_SECURITY-4-GBIC_INTERR: Internal error occurred in setup for GBIC
interface [chars].
Explanation The system could not allocate resources or had some other problem during the setup for
the specified SFP module interface. [chars] is the interface in which the SFP module is installed.
Recommended Action Reload the switch by using the reload privileged EXEC command. If the
problem persists, find out more about the error by using the show tech-support privileged EXEC
command and by copying the error message exactly as it appears on the console or system log and
entering it in the Output Interpreter tool. Use the Bug Toolkit to look for similar reported problems. For
more information about these online tools and about contacting Cisco, see the
“Error Message
Traceback Reports” section on page 1-4.
Error Message GBIC_SECURITY-6-SFP_INSERTED: Transceiver SFP [chars] module inserted
in [chars]
Explanation The online insertion and removal (OIR) facility detected a newly inserted transceiver
module for the interface specified in the message. The first [chars] is the module and the second
[chars] is the interface.
Recommended Action No action is required.
Error Message GBIC_SECURITY-6-SFP_REMOVED: Transceiver SFP [chars] module removed
from [chars]
Explanation The online insertion and removal (OIR) facility detected the removal of a transceiver
module from the interface specified in the message. The first [chars] is the module and the second
[chars] is the interface.
Recommended Action No action is required.
GBIC_SECURITY_CRYPT Messages
This section contains the Cisco GBIC module and SFP module security messages. The switch recognizes
the module as a Cisco module but identifies another problem with it.
Note The Cisco IE 3000 switch supports SFP modules and does not support GBIC modules. Although the
error message text refers to GBIC interfaces and modules, the messages from the switch actually refer
to the SFP module interfaces and modules.