Cisco IE-3000-8TC Message Guide

2-16
Cisco IE 3000 Switch System Message Guide
OL-13020-01
Chapter 2 Message and Recovery Procedures
DTP Messages
Error Message DTP-4-TMRERR: An internal timer error occurred when trunking on
interface [chars].
Explanation A timer used by the trunking protocol unexpectedly expired. [chars] is the trunked
interface.
Recommended Action This problem is corrected internally and has no long-term ramifications.
However, if more problems with trunking occur, reload the switch by using the reload privileged
EXEC command.
Error Message DTP-4-UNKN_ERR: An unknown operational error occurred.
Explanation The system is unable to negotiate trunks because an internal operation generated an
unexpected error.
Recommended Action Reload the switch by using the reload privileged EXEC command.
Error Message DTP-5-DOMAINMISMATCH: Unable to perform trunk negotiation on port
[chars] because of VTP domain mismatch.
Recommended Action The two ports in the trunk negotiation belong to different VTP domains.
Trunking can be configured only when the ports belong to the same VTP domain. [chars] is the port
number.
Recommended Action Ensure that the ports in the trunk negotiation belong to the same VTP domain.
Error Message DTP-5-ILGLCFG: Illegal config (on, isl--on,dot1q) on [chars].
Explanation One end of the trunk link is configured as on with ISL encapsulation and the other end
is configured as on with IEEE 802.1Q encapsulation. [chars] is the interface.
Recommended Action This configuration is illegal and will not establish a trunk between two
switches. You must change the encapsulation type so that both ends of the trunk match.
Error Message DTP-5-NONTRUNKPORTON: Port [chars] has become non-trunk.
Explanation The interface changed from a trunk port to an access port. [chars] is the interface that
changed.
Recommended Action This message is provided for information only.
Error Message DTP-5-TRUNKPORTCHG: Port [chars] has changed from [chars] trunk to
[chars] trunk.
Explanation The encapsulation type of the trunk port has changed. The first [chars] is the interface,
the second is the original encapsulation type, and the third [chars] is the new encapsulation type.
Recommended Action This message is provided for information only.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes