EasyManuals Logo

Cisco IE-3000-8TC Message Guide

Cisco IE-3000-8TC
98 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #64 background imageLoading...
Page #64 background image
2-50
Cisco IE 3000 Switch System Message Guide
OL-13020-01
Chapter 2 Message and Recovery Procedures
QOSMGR Messages
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, open a case
with the TAC, or contact your Cisco technical support representative, and provide the representative
with the gathered information. For more information about these online tools and about contacting
Cisco, see the
“Error Message Traceback Reports” section on page 1-4.
Error Message QOSMGR-4-ACTION_NOT_SUPPORTED: Action is not supported in policymap
[chars].
Explanation An action other than the set, trust, and police policy-map class configuration
commands was configured in a policy map. This is a hardware limitation. [chars] is the policy-map
name.
Recommended Action Configure only the supported actions of set, trust, and police when in
policy-map class configuration mode.
Error Message QOSMGR-4-CLASS_NOT_SUPPORTED: Classification is not supported in
classmap [chars].
Explanation An unsupported match class-map configuration command was configured in a policy
map and attached to an egress interface, or more than one match class-map command was
configured. This is a hardware limitation. [chars] is the class-map name.
Recommended Action Reconfigure the class map or the policy map. Use only the match ip dscp
dscp-list class-map configuration command in a policy map that is attached to an egress interface.
Only one match per class map is supported.
Error Message QOSMGR-4-COMMAND_FAILURE: Execution of [chars] command failed.
Explanation The command to configure a QoS setting failed. This is possibly due to lack of hardware
resources. [chars] is the description of the command.
Recommended Action Check if any other messages indicate resource failure. If other messages
indicate that the hardware resources are exceeded, retry the command with a smaller configuration.
Find out more about the error by using the show tech-support privileged EXEC command and by
copying the error message exactly as it appears on the console or system log and entering it in the Output
Interpreter tool. Use the Bug Toolkit to look for similar reported problems. For more information about
these online tools and about contacting Cisco, see the
“Error Message Traceback Reports” section on
page 1-4.
Error Message QOSMGR-4-HARDWARE_NOT_SUPPORTED: Hardware limitation has reached for
policymap [chars].
Explanation The policy-map configuration has exceeded the limitation of the hardware. You
configured more QoS ACL entries than the number specified in the Switch Database Management
(SDM) template. [chars] is the policy-map name.
Recommended Action Reconfigure the class map or the policy map, and reduce the number of QoS
ACLs.

Table of Contents

Other manuals for Cisco IE-3000-8TC

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco IE-3000-8TC and is the answer not in the manual?

Cisco IE-3000-8TC Specifications

General IconGeneral
Switching Capacity16 Gbps
MAC Address Table Size8000
Uplink Ports2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature-40°C to 70°C
MountingDIN rail
Ports8 x Ethernet 10/100Base-TX ports
Jumbo Frame SupportYes

Related product manuals