EasyManuals Logo

Cisco IE-3000-8TC Message Guide

Cisco IE-3000-8TC
98 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #73 background imageLoading...
Page #73 background image
2-59
Cisco IE 3000 Switch System Message Guide
OL-13020-01
Chapter 2 Message and Recovery Procedures
SPANTREE Messages
contact your Cisco technical support representative, and provide the representative with the
gathered information. For more information about these online tools and about contacting Cisco, see
the
“Error Message Traceback Reports” section on page 1-4.
Error Message SPANTREE-5-EXTENDED_SYSID: Extended SysId [chars] for type [chars].
Explanation The extended system ID feature is either enabled or disabled for the given type of
spanning tree. If enabled, the spanning-tree instance identifier is stored in the lower portion of the
bridge ID priority field and limits the allowed values for the bridge priority from 0 to 61440, in
increments of 4096. If disabled, the bridge ID priority field consists only of the configured priority,
but some spanning-tree features might not be available on a given platform (for example, support
for 4096 VLANs). On some platforms, this feature might be mandatory. The first [chars] is the
extended system ID state (enable or disable), and the second [chars] is the spanning-tree instance.
Recommended Action No action is required.
Error Message SPANTREE-5-ROOTCHANGE: Root Changed for [chars] [dec]: New Root Port
is [chars]. New Root Mac Address is [enet].
Explanation The root switch changed for a spanning-tree instance. The first [chars] and [dec] is the
interface ID for the previous root port, the second [chars] is the interface ID for the new root port,
and [enet] is the Ethernet address of the new root port.
Recommended Action No action is required.
Error Message SPANTREE-5-TOPOTRAP: Topology Change Trap for [chars] [dec].
Explanation A trap was generated because of a topology change in the network.
Recommended Action No action is required.
Error Message SPANTREE-6-PORTADD_ALL_VLANS: [chars] added to all Vlans
Explanation The interface has been added to all VLANs. [chars] is the added interface.
Recommended Action No action is required.
Error Message SPANTREE-6-PORTDEL_ALL_VLANS: [chars] deleted from all Vlans
Explanation The interface has been deleted from all VLANs. [chars] is the deleted interface.
Recommended Action No action is required.

Table of Contents

Other manuals for Cisco IE-3000-8TC

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco IE-3000-8TC and is the answer not in the manual?

Cisco IE-3000-8TC Specifications

General IconGeneral
Switching Capacity16 Gbps
MAC Address Table Size8000
Uplink Ports2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature-40°C to 70°C
MountingDIN rail
Ports8 x Ethernet 10/100Base-TX ports
Jumbo Frame SupportYes

Related product manuals