Cisco IE 4000

18
Switch Installation
Connecting to Power
Connecting to Power
Tools and Equipment
Obtain these necessary tools and equipment:
 Ratcheting torque flathead screwdriver that exerts up to 18 in-lb (2.03 N-m) of pressure.
 For the protective ground connector, obtain a single or pair of stu size 6 ring terminals (such as Hollingsworth part
number R3456B or equivalent).
 Crimping tool (such as Thomas & Bett part number WT4000, ERG-2001, or equivalent).
 10-gauge copper ground wire.
 For DC power connections, use UL- and CSA-rated, style 1007 or 1569 twisted-pair copper appliance wiring
material (AWM) wire.
 Wire-stripping tools for stripping 10- and 18-gauge wires.
 A number-2 Phillips screwdriver.
 A flat-blade screwdriver.
Supported Power Supplies
The supported power supplies are listed in Table 2 on page 19.