Cisco Line Card 4500 E-Series User Manual

C-1
Catalyst 4500 E-Series Switches Installation Guide
OL-13972-02
APPENDIX
C
Initial Configuration for the Switch
Revised: October 25, 2011
This appendix provides an initial setup procedure for a switch and contains the following topics:
• Connecting to the Switch, page C-2
• Starting the Terminal-Emulation Software, page C-2
• Connecting to a Power Source, page C-2
• Entering the Initial Configuration Information, page C-3
Tip For additional information about the Catalyst 4500 E-series switches (including configuration examples
and troubleshooting information), see the documents listed on this page:
http://preview.cisco.com/en/US/products/hw/switches/ps4324/tsd_products_support_series_home.html
Note You need to provide the Category 5 straight-through cables to connect the switch ports to other
Ethernet devices.
Note If you move a supervisor engine from a Catalyst 4500 series chassis to a Catalyst 4503-E chassis or
Catalyst 4506-E chassis, it must use Cisco IOS Release
12.2(37)SG or later releases. See the release note
for software upgrade procedures if needed:
http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/release/note/OL_5184.html#wp305142

Cisco Line Card 4500 E-Series Specifications

General

Brand	Cisco
Model	Line Card 4500 E-Series
Category	Switch
Language	English