Cisco MDS 9700 Series User Manual

<Tue Apr 30 10:02:47 2019> ERROR!!! Supervisor-4 (DS-X97-SF4-K9) image links
could not be created for Standby Supervisor bootup, aborting migration...
Solution Use the migrate sup kickstart < supervisor4-kickstart-image > system < supervisor4-system-image
> command again.
Problem Unable to reload the Supervisor-4 Module after the Supervisor-4 Module is detected in the switch.
The following syslog message is displayed:
<Tue Apr 30 10:02:47 2019> ERROR!!! Failed to reload
Standby Supervisor-4 (DS-X97-SF4-K9), aborting migration...
Solution Remove the Supervisor-4 Module from the standby slot and restart migration by using the migrate
sup kickstart < supervisor4-kickstart-image > system < supervisor4-system-image > command.
Problem The Supervisor-4 Module is stuck in loader prompt due to a boot failure. The following syslog message
is displayed:
<Tue Apr 30 10:02:47 2019> ERROR!!! Standby Supervisor-4
(DS-X97-SF4-K9) is stuck in loader prompt due to boot-up failure...
Solution None. A retry attempt to bring up the Supervisor-4 Module is initiated by the switch every 15 minutes
for 3 times.
Problem The Supervisor-4 Module is unable to come online. The following syslog message is displayed:
<Tue Apr 30 10:02:47 2019> ERROR!!! Standby Supervisor-4
(DS-X97-SF4-K9) could not come online...
Solution None. A retry attempt to bring up the Supervisor-4 Module is initiated by the switch every 15 minutes.
Problem The supervisor module fails to come online. The following syslogs are displayed:
<Tue Apr 30 10:02:47 2019> ERROR!!! Timeout waiting for Supervisor-4
(DS-X97-SF4-K9) to come online, aborting migration...
<Tue Apr 30 10:02:47 2019> Powering down Supervisor-4 (DS-X97-SF4-K9) in slot <slot_number>
Solution Use the migrate sup kickstart < supervisor4-kickstart-image > system < supervisor4-system-image
> command again.
Problem The Supervisor-1 Module image links are not restored on the active Supervisor-1 Module before the
switchover to Supervisor-4 Module is initiated. The following syslogs are displayed before saving configuration:
<Tue Apr 30 10:02:47 2019> WARNING!!! Error resetting original Supervisor-3 (DS-X97-SF1-K9)
image links, continuing migration...
<Tue Apr 30 10:02:47 2019> WARNING!!! Please set the boot variables manually before inserting
back
Supervisor-3 (DS-X97-SF1-K9) in standby slot <slot_number>, continuing migration...
Solution Use the migrate sup kickstart < supervisor4-kickstart-image > system < supervisor4-system-image
> command again.
Problem The copy r s command fails on the active Supervisor-1 Module before the switchover to the
Supervisor-4 Module is initiated. The following syslog is displayed:
<Tue Apr 30 10:02:47 2019> ERROR!!! Failed to save configuration, aborting migration...
Solution Use the migrate sup kickstart < supervisor4-kickstart-image > system < supervisor4-system-image
> command again.
Problem The switchover fails on the active Supervisor-1 Module before the switchover to the Supervisor-4
Module is initiated. The following syslog is displayed:
Cisco MDS 9700 Series Switches Hardware Installation Guide
148
Installing, Removing, and Verifying Field Replaceable Units
Troubleshooting

Cisco MDS 9700 Series Specifications

General

Brand	Cisco
Model	MDS 9700 Series
Category	Switch
Language	English