Cisco MDS 9700 Series User Manual

---- System Admin Account Setup ----
Do you want to enforce secure password standard (yes/no) [y]:
Enter the password for “admin”:
Enter the password for “admin”:
Step 12 When you are asked to enter the basic configuration, enter no.
---- Basic System Configuration Dialog VDC: 1 ----
This setup utility will guide you through the basic configuration of the system. Setup configures
only enough connectivity for management of the system.
Please register Cisco Nexus7000 Family devices promptly with your supplier. Failure to register may
affect response times for initial service calls. Nexus7000 devices must be registered to receive
entitled support services.
Press Enter at anytime to skip a dialog. Use ctrl-c at anytime
to skip the remaining dialogs.
Would you like to enter the basic configuration dialog (yes/no): no
Step 13 When asked to log in, enter the login and password that you specified in step Step 11, on page 151.
User Access Verification
switch login:
Password:
Step 14 Verify that the switch is running the required version of the Cisco MDS NX-OS software by using the show version
command.
switch(config)# show version
If the version of the Cisco MDS NX-OS is not the same as you intended to use, perform an upgrade to the
appropriate version (Cisco MDS NX-OS Release 8.4(1) or later). To upgrade an image version on the
switch, refer the Cisco MDS 9000 NX-OS Software Upgrade and Downgrade Guide, Release 8.x guide.
Note
Step 15 Reinstall the license files on the new Supervisor-4 Module.
switch(config)# copy usb1:licenses_archive_file_name.tar bootflash:switch_license.tar
Copy progress 100% 10KB
Copy complete, now saving to disk (please wait)...
switch(config)# copy bootflash:switch_license.tar bootflash:switch_license.lic
Copy progress 100% 10KB
Copy complete, now saving to disk (please wait)...
switch(config)# install license bootflash:switch_license.lic
Installing license...........................done
switch# show license usage
Feature Ins Lic Status Expiry Date Comments
Count
--------------------------------------------------------------------------------
IOA_X9334 No 0 In use Grace 115D 2H
FM_SERVER_PKG No - Unused -
MAINFRAME_PKG No - Unused -
ENTERPRISE_PKG Yes - Unused never -
SAN_ANALYTICS_PKG No - In use Grace 119D 20H
SAN_TELEMETRY_PKG No - Unused Grace 109D 1H
--------------------------------------------------------------------------------
Step 16 Make sure that all I/O modules are online and that the standby supervisor is in HA-standby mode by using the show
module command.
Cisco MDS 9700 Series Switches Hardware Installation Guide
152
Installing, Removing, and Verifying Field Replaceable Units
Disruptive Migration for Supervisor Modules

Cisco MDS 9700 Series Specifications

General

Brand	Cisco
Model	MDS 9700 Series
Category	Switch
Language	English