Cisco NCS 5500 Series Configuration Guide

Example:
RP/0/RP0/CPU0:router(config-bgp-rpki-server)#refresh-time 20
Or
RP/0/RP0/CPU0:router(config-bgp-rpki-server)#refresh-time off
Configures the time BGP waits in between sending periodic serial queries to the cache. Set refresh-time in seconds.
Range for the refresh time is 15 to 3600 seconds.
Configure the off option to specify not to send serial-queries periodically.
Step 10
Use one these commands.
•
response-time time
•
response-time off
Example:
RP/0/RP0/CPU0:router(config-bgp-rpki-server)#response-time 30
Or
RP/0/RP0/CPU0:router(config-bgp-rpki-server)#response-time off
Configures the time BGP waits for a response after sending a serial or reset query. Set response-time in seconds. Range
for the response time is 15 to 3600 seconds.
Configure the off option to wait indefinitely for a response.
Step 11
shutdown
Example:
RP/0/RP0/CPU0:router(config-bgp-rpki-server)#shutdown
Configures shut down of the RPKI cache.
Step 12
commit
Configure RPKI Prefix Validation
Perform this task to control the behavior of RPKI prefix validation processing.
SUMMARY STEPS
1.
configure
2.
router bgp as-number
3.
Use one of these commands.
•
rpki origin-as validation disable
•
rpki origin-as validation time {off | prefix_validation_time
4.
origin-as validity signal ibgp
5.
commit
BGP Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.2.x
93
Implementing BGP
BGP Prefix Origin Validation Based on RPKI

Cisco NCS 5500 Series Specifications

General

Series	NCS 5500
Category	Network Router
Operating System	Cisco IOS XR
Product Type	Modular Router
Form Factor	Rack-mountable
Purpose	High-performance routing for service providers and large enterprises
Interface Types	Ethernet
Redundancy	Redundant power supplies and fan trays
Port Density	Varies by model; high-density configurations available
Routing Protocols	BGP, OSPF, IS-IS, MPLS
Power Supply Options	AC and DC power supplies available
Management	CLI, SNMP, NETCONF