Cisco NCS 5500 Series

•
send-extended-community-ebgp
Example:
RP/0/RP0/CPU0:router(config-bgp-nbr-af)# send-community-ebgp
or
RP/0/RP0/CPU0:router(config-bgp-nbr-af)# send-extended-community-ebgp
Specifies that the router send community attributes or extended community attributes (which are disabled by default for
eBGP neighbors) to a specified eBGP neighbor.
Step 7
commit
Redistribute iBGP Routes into IGP
Perform this task to redistribute iBGP routes into an Interior Gateway Protocol (IGP), such as Intermediate
System-to-Intermediate System (IS-IS) or Open Shortest Path First (OSPF).
Use of the bgp redistribute-internal command requires the clear route * command to be issued to
reinstall all BGP routes into the IP routing table.
Note
Redistributing iBGP routes into IGPs may cause routing loops to form within an autonomous system. Use
this command with caution.
Caution
SUMMARY STEPS
1.
configure
2.
router bgp as-number
3.
bgp redistribute-internal
4.
commit
DETAILED STEPS
Step 1
configure
Step 2
router bgp as-number
Example:
RP/0/RP0/CPU0:router(config)# router bgp 120
Specifies the autonomous system number and enters the BGP configuration mode, allowing you to configure the BGP
routing process.
Step 3
bgp redistribute-internal
BGP Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.2.x
56
Implementing BGP
Redistribute iBGP Routes into IGP