Cisco NCS 5500 Series

Step 3
address-family l2vpn evpn
Example:
RP/0/RP0/CPU0:router(config-bgp)# address-family l2vpn evpn
Specifies the L2VPN address family and enters address family configuration mode.
Step 4
neighbor ip-address
Example:
RP/0/RP0/CPU0:router(config-bgp)# neighbor 10.10.10.1
Adds the IP address of the neighbor in the specified autonomous system.
Step 5
address-family l2vpn evpn
Example:
RP/0/RP0/CPU0:router(config-bgp-nbr-af)# address-family l2vpn evpn
Specifies the L2VPN address family of the neighbor and enters address family configuration mode.
Step 6
Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
•
Yes - Saves configuration changes and exits the configuration session.
•
No - Exits the configuration session without committing the configuration changes.
•
Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring EVPN-VPWS
Perform this task to configure EVPN-VPWS.
SUMMARY STEPS
1.
configure
2.
interface type interface-path-id
3.
l2vpn
4.
xconnect group group-name
5.
p2p xconnect-name
6.
interface type interface-path-id
7.
neighbor evpn evi vpn-idtarget ac-id source ac-id
8.
Use the commit or end command.
BGP Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.2.x
149
EVPN Virtual Private Wire Service (VPWS)
Configuring EVPN-VPWS