Cisco NCS 5500 Series - Page 139

SetMatchAttributeAttach Point
—
in
is-local
length
neighbor-is
originates-from
passes-through
unique-length
as-pathshow
—
is, ge, le, eqas-path-length
—
is, ge, le, eqas-path-unique-length
—
is-empty
matches-any
matches-every
community
—
indestination
—
is-empty
matches-any
matches-every
matches-within
extcommunity rt
—
is-empty
matches-any
matches-every
matches-within
extcommunity soo
—
is, eg, ge, lemed
—
innext-hop
—
isorigin
—
insource
Some BGP route attributes are inaccessible from some BGP attach points for various reasons. For example,
the set med igp-cost only command makes sense when there is a configured igp-cost to provide a source
value.
This table summarizes which operations are valid and where they are valid.
BGP Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.2.x
129
Implementing BGP
Information about Implementing BGP