Cisco NCS 5500 Series

RP/0/RP0/CPU0:router# show ospf interface
Interfaces for OSPF test
TenGigE0/0/0/7 is up, line protocol is up
Internet Address 7.7.7.3/16, Area 1
Label stack Primary label 0 Backup label 0 SRTE label 0
Process ID test, Router ID 7.7.7.3, Network Type BROADCAST, Cost: 1 (RSVP-TE)
Transmit Delay is 1 sec, State DR, Priority 1, MTU 1500, MaxPktSz 1500
Forward reference No, Unnumbered no, Bandwidth 10000000
Designated Router (ID) 7.7.7.3, Interface address 7.7.7.3
Backup Designated router (ID) 7.7.7.2, Interface address 7.7.7.2
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:01:801
Index 1/1, flood queue length 0
Next 0(0)/0(0)
Last flood scan length is 2, maximum is 2
Last flood scan time is 0 msec, maximum is 0 msec
LS Ack List: current length 0, high water mark 1
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 7.7.7.2 (Backup Designated Router)
Suppress hello for 0 neighbor(s)
Keychain-based authentication enabled
Key id used is 1
Cryptographic algorithm HMAC-SHA-256
Multi-area interface Count is 0
(Optional) Displays OSPF interface information.
Step 6 show { ospf | ospfv3 }[ process-name ] [ area-id ] neighbor [ t ype interface- path-id ] [ neighbor-id ] [ detail ]
Example:
RP/0/RP0/CPU0:router# show ospf 100 neighbor
(Optional) Displays OSPF neighbor information on an individual interface basis.
Step 7 clear { ospf | ospfv3 }[ process-name ] process
Example:
RP/0/
/CPU0:router# clear ospf 100 process
(Optional) Resets an OSPF router process without stopping and restarting it.
Step 8 clear{ospf|ospfv3[ process-name ] redistribution
Example:
RP/0/RP0/CPU0:router#clear ospf 100 redistribution
Clears OSPF route redistribution.
Step 9 clear{ospf|ospfv3[ process-name ] routes
Example:
RP/0/RP0/CPU0:router#clear ospf 100 routes
Clears OSPF route table.
Step 10 clear{ospf|ospfv3[ process-name ] vrf [vrf-name|all] {process |redistribution|routes|statistics [interface type
interface-path-id|message-queue|neighbor]}
Routing Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.3.x
50
Implementing OSPF
Verify OSPF Configuration and Operation