Figure 55: Attaching a Lower Cable Management Assembly to a Rack-Mount Bracket
Position the assembly so that the two lower hooks on the rack-mount bracket
fit inside the two holes on the assembly, and then slide the assembly down so
that it is held by the hooks.
3Lower cable management
assembly.
1
Loosely fasten the assembly to the rack-mount bracket with four M4x10
screws. Do not tighten these screws.
4Rack-mount bracket.2
Step 2 Repeat Step 1 to attach a lower cable management assembly to the right side of the chassis.
Step 3 Attach an upper cable management assembly (800-31342-01) onto the two hooks that protrude from the upper half of
the left rack-mount bracket that is attached to the Cisco Nexus 7018 switch chassis, and loosely fasten the assembly to
the chassis with four flat-head M4x10 screws as shown in Figure 56: Attaching a Left Cable Management Assembly
to a Rack-Mount Bracket, on page 111.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
110
Installing a Cisco Nexus 7018 Chassis
Installing the Cable Management Frame
To Next Page
Loading...
