Cisco Nexus 7004 - Connecting Your ESD Wrist Strap to the Chassis

Figure 53: Grounding Pad on the Cisco Nexus 7018 Chassis
Grounding
port
1
Step 5 Prepare the other end of the grounding wire and connect it to an appropriate grounding point in your site to ensure an
adequate earth ground for the switch. If the rack is grounded, connect the grounding wire as explained in the documentation
provided by the vendor for the rack.
Connecting Your ESD Wrist Strap to the Chassis
After you connect the chassis to the earth ground, you can ground your ESD wrist strap by plugging it into
the ESD port shown in Figure 54: ESD Grounding Ports on the Front of the Cisco Nexus 7018 Chassis, on
page 108.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
107
Installing a Cisco Nexus 7018 Chassis
Connecting Your ESD Wrist Strap to the Chassis