• CAB-HV-25A-SG-IN3—power cord, 300-VAC 20A, Saf-D-Grid P-10/Saf-D-Grid P4, IEC/EU,
International
All cables will not be orderable at first customer shipment (FCS).
Note
The available DC power cords for the 3.5-kW HVAC/HVDC power supplies are as follows:
• CAB-HV-25A-SG-US1—power cord, 400-VDC 20A, Saf-D-Grid/Saf-D-Grid, North America
• CAB-HV-25A-SG-US2—power cord, 300-VAC/500-VDC 20A, Ring Terminal/Saf-D-Grid, North
America
• CAB-HV-25A-SG-IN1—power cord, 400-VDC 20A, IEC/EU, Saf-D-Grid/Saf-D-Grid, International
• CAB-HV-25A-SG-IN2—power cord, 300-VAC/500-VDC 20A, IEC/EU, Ring Terminal/Saf-D-Grid,
International
All cables will not be orderable at first customer shipment (FCS).
Note
Cisco Nexus 7009 Switch Accessory and Optional Kits
This section describes the contents of the Cisco Nexus 7009 accessory kits and the other kits that you can
order for the Cisco Nexus 7009 switch. The accessory kit is shipped with each Cisco Nexus 7009 chassis.
You use that kit for mounting the front of the chassis on a four-post or two-post rack. If you are centering the
chassis on a two-post rack, you must also order the Cisco Nexus 7009 Center Mount Kit (part number
N7K-C7009-CMK). If you need to another bottom support bracket for front-mounting the chassis, order the
Cisco Nexus 7009 Bottom Support Kit (part number N7K-C7009-BSK). If you need an additional set of
brackets for mounting the front of the chassis to a rack, order the Cisco Nexus 7009 Rack Mount Kit (part
number N7K-C7009-RMK).
This section includes the following topics:
Cisco Nexus 7009 Accessory Kit
The Cisco Nexus 7009 Accessory Kit is shipped with each Cisco Nexus 7009 chassis. Table 57: Cisco Nexus
7009 Switch Accessory Kit Contents , on page 235 lists and illustrates the contents for this kit.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
234
Accessory Kits Contents
Cisco Nexus 7009 Switch Accessory and Optional Kits
To Next Page
Loading...
