EasyManua.ls Logo

Cisco Nexus 7004 - Cisco Nexus 7009 Chassis Clearances

Cisco Nexus 7004
274 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chassis width9Cable management frames2
Right side clearance recommended for open rack
installations:
If next to another open rack, use 6 inches
(15.2 cm) between racks.
If next to a wall, use 11 inches (27.9 cm)
between chassis and wall.
10Vertical rack-mount posts3
No rear clearance required but the rear must be
open to the hot aisle to exhaust air
11Vertical rack-mount posts for neighboring rack4
Distance from front of vertical rack-mount posts
to rear of chassis
12Air intake from cold aisle for power supplies5
Clearance required between the front of the
chassis and the inside of the chassis for the cable
management frames and the optional front doors
13Air intake from cold aisle for the supervisor and
I/O modules
6
Front service clearance required for installing
the chassis and replacing the modules
14Air exhaust to hot aisle for all modules and
power supplies
7
Cisco Nexus 7009 Chassis Clearances
The Cisco Nexus 7009 chassis has different clearance requirements for installations with four-post racks or
cabinets, two-post racks with front-mount brackets, and two-post racks with center-mount brackets.
For four-post rack or cabinet installations, the chassis requires the following clearances (see Figure 135:
Clearances Required for a Front-Mounted Cisco Nexus 7009 Chassis in a Four-Post Rack, on page 192):
Front clearance requires both of the following:
Cabling area of 7.5 inches (19.1 cm) between the front of the chassis and the inside surface of the
cabinet or rack (this area can include the optional cable management frames)
Maintenance area of 24 inches (61.1 cm) between the front of the rack or cabinet and the next object
in the cold aisle.
You might need to increase the maintenance area to accommodate a wide mechanical lift used to move the
chassis to or from the rack.
Note
Rear clearance includes both of the following:
Cabling area of 7 inches (17.8 cm) between the rear of the chassis and the inside surface of the
cabinet or rack
Maintenance area of 24 inches (61.1 cm) between the rear of the rack or cabinet and the next object
in the hot aisle
Side clearance of 11 inches (27.9 cm) for air flow on each side of the chassis.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
191
Technical Specifications
Cisco Nexus 7009 Chassis Clearances

Table of Contents

Related product manuals