CHAPTER 4
Installing a Cisco Nexus 7010 Chassis
This chapter describes how to install a new or relocated Cisco Nexus 7010 chassis in a rack or cabinet. For
information about installing other Cisco Nexus 7000 Series chassis or power supplies, see the following
chapters:
This chapter includes the following sections:
• Preparing to Install the Switch, on page 69
• Installing the Bottom-Support Rails on the Rack, on page 72
• Installing the Chassis, on page 75
• Grounding the Cisco Nexus 7010 Chassis, on page 79
• Installing Storage Media in a Supervisor Module, on page 84
• Installing the Front Doors and Frame Assembly, on page 85
• Installing the Air Filter, on page 92
Preparing to Install the Switch
This section includes the following topics:
You must set up one four-post, 19-inch EIA rack or cabinet before you can install the Cisco Nexus 7010
chassis. Make sure that you order the rack or cabinet and have it delivered before installing the chassis.
Note
Required Tools
Before you install the Cisco Nexus 7010 chassis into a rack, make sure that you have the following tools and
equipment:
• Mechanical lift capable of lifting 550 pounds (250 kg)
• Number 1 Phillips screwdriver with torque capability
• 3/16-inch flat-blade screwdriver
• Crimping tool
• Wire stripping tool
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
69
To Next Page
Loading...
