DescriptionStatusLED
All diagnostics pass. The CMP is operational (normal initialization sequence).
GreenCMP STATUS (Supervisor 1
module only)
Sufficient power is not available for all modules.Amber
The diagnostic test has failed.
or
The CMP is not operational because a fault has occurred during the
initialization sequence.
Flashing amber
The module has detected a slot ID parity error.Red
The CMP is not receiving power.Off
The module has detected a link.
GreenLINK (Supervisor 1 module
only)
The module has not detected a link.Off
The module is transmitting or receiving.
Flashing greenACT (Supervisor 1 module
only)
The module is not transmitting or receiving.Off
I/O Module LEDs
Table 65: I/O Module LEDs , on page 246 describes the I/O module LEDs.
Table 65: I/O Module LEDs
DescriptionStatusLED
The operator has activated this LED to identify this module in the chassis.Flashing blueID
This module is not being identified.Off
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
246
Chassis and Module LEDs
I/O Module LEDs
To Next Page
Loading...
