Cisco Nexus 7004 - Page 257

DescriptionStatusLED
The supervisor module is operational and active.
GreenACTIVE
The supervisor module is in standby mode.Amber
Sufficient power is available for all of the installed modules.
GreenPWR MGMT
Insufficient power is available for all of the installed modules.Amber
The management port is operational.
GreenMGMT ETH
The management port link has been disabled through the software.Amber
The management port link is bad and has been disabled due to a hardware
failure.
Flashing Amber
The module has not detected a signal.Off
The module has detected a link.
GreenLINK
The module does not detect a link.Off
The module is transmitting or receiving.
Flashing greenACT
The module is not transmitting or receiving.Off
The log flash CompactFlash or USB disk is being accessed. Do not remove
the media until the LED is off.
GreenACT LOG FLASH
(Supervisor 1)
LOG FLASH(Supervisor 2 and
2E)
The expansion flash CompactFlash or USB disk is not being accessed. You
can remove the media while this LED is off.
Off
The expansion flash CompactFlash or USB disk is being accessed. Do not
remove the media until the LED is off.
GreenACT EXPANSION
FLASH(Supervisor 1)
Slot 0(Supervisor 2 and 2E)
The log flash CompactFlash or USB disk is not being accessed. You can
remove the media while this LED is off.
Off
The management port is operational.
GreenCMP MGMT ETH (Supervisor
1 module only)
The management port link has been disabled through the software.Amber
The management port link is bad and has been disabled due to a hardware
failure.
Flashing amber
The module does not detect a signal.Off
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
245
Chassis and Module LEDs
Supervisor Module LEDs