Cisco Nexus 7004 - Supervisor Module Leds

ConditionColorLED
Fabric modules are all operational.GreenFAB
At least one fabric module has a red STATUS LED.Amber
The modules in the I/O slots are all operational.GreenIOM
At least one module in the I/O slots has a red STATUS LED.Amber
Supervisor Module LEDs
Table 64: Supervisor Module LEDs , on page 244 describes the supervisor module LEDs.
Table 64: Supervisor Module LEDs
DescriptionStatusLED
All diagnostics pass. The module is operational (normal initialization
sequence).
GreenSTATUS
The module has detected a slot ID parity error and will not power on or boot
up.
or
The module is not fully inserted and does not have a reliable connection to
the midplane.
or
The diagnostic test has failed.
Red
The inlet air temperature of the system has exceeded the safe operating
temperature limits of the module (a major environmental warning). The
module has been shut down to prevent permanent damage. The system will
be shut down after two minutes if this condition is not cleared.
or
The module is resetting, and both ejector levers are out.
Flashing red
The module is not receiving power.Off
The operator has activated this LED to identify this module in the chassis.
Flashing blueID
This module is not being identified.Off
All chassis environmental monitors are reporting okay.
GreenSYSTEM
At least one power supply has failed or the power supply fan has failed.Amber
The temperature of the supervisor engine major threshold has been exceeded.Red
The slot has detected a slot ID parity error.Off
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
244
Chassis and Module LEDs
Supervisor Module LEDs