Send document comments to nexus7k-docfeedback@cisco.com
7-48
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-06
Chapter 7 Managing the Switch Hardware
Configuring EPLDs
Example 7-13 Displaying the Available EPLD Versions
switch# show version epld bootflash:n7000-s1-epld.6.0.1.img
...
Module Type EPLD Device Version
-----------------------------------------------------------------
Supervisor-1X Power Manager 3.009
Supervisor-1X IO 3.028
Supervisor-1X Inband 1.008
Supervisor-1X Local Bus CPLD 3.000
Supervisor-1X CMP CPLD 6.000
...
10/100/1000 Mbps Eth Module Power Manager 5.006
10/100/1000 Mbps Eth Module IO 2.014
10/100/1000 Mbps Eth Module Forwarding Engine 1.006
10 Gbps Ethernet Module Power Manager 4.008
10 Gbps Ethernet Module IO 1.016
10 Gbps Ethernet Module Forwarding Engine 1.006
10 Gbps Ethernet Module FE Bridge 186.008
10 Gbps Ethernet Module Linksec Engine 2.007
1000 Mbps Optical Ethernet Module Power Manager 4.008
1000 Mbps Optical Ethernet Module IO 1.006
1000 Mbps Optical Ethernet Module Forwarding Engine 1.006
1000 Mbps Optical Ethernet Module SFP 1.004
...
Fabric Module 2 Power Manager 1.003
Fabric Module 2 Power Manager 1.003
...
Fan<Cisco Nexus 7009> Fan Controller 0.007
Fan<Cisco Nexus 7009> Fan Controller 0.007
Displaying the Status of EPLD Upgrades
To display the status of EPLD upgrades on the switch, use the show install epld status command as
shown in Example 7-14.
Example 7-14 Displaying EPLD Upgrades
switch# show install epld status
1) Xbar Module 4 upgraded on Wed Oct 26 16:36:27 2011 (524778 us)
Status: EPLD Upgrade was Successful
EPLD Curr Ver Old Ver
------------------------------------------------------
Power Manager 1.003 1.003
2) Module 14 upgraded on Mon May 23 19:45:55 2011 (835895 us)
Status: EPLD Upgrade was Successful
...
To Next Page
Loading...
Need help?
General