Figure 22: Removing the Front-Mount Brackets
Remove the bracket from the chassis2Remove five screws from each bracket1
b) Position the center-mount bracket so that its five screw holes are aligned to the five screw holes used for the front-mount
bracket (see ).
Fasten the bracket to the chassis using five screws
previously used to hold a front-mount bracket to the
chassis.
2Position the center-mount bracket with its five screw
holes aligned to the five screw holes in the chassis.
1
c) Fasten the bracket to the chassis with the five screws previously removed from the front-mount bracket.
d) Repeat Steps b and c for attaching the other center-mount bracket to the other side of the chassis.
Step 2 Load the chassis onto a mechanical lift as follows:
a) Position the mechanical lift next to the shipping pallet that holds the chassis.
b) Elevate the lift platform to the level of the bottom of the chassis (or no more than 0.25 inches [0.635 cm] below the
bottom of the chassis).
c) Use at least two persons to slide the chassis fully onto the lift so that the side of the chassis touches or is close to the
vertical rails on the lift. Make sure that the front and rear of the chassis are unobstructed so you can easily push the
chassis into the rack.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
52
Installing a Cisco Nexus 7009 Chassis
Mounting the Chassis by its Center Brackets
To Next Page
Loading...
