Push the lower half of the front side of the chassis so that the back side enters the rack first, and push until the chassis
mounting brackets come in contact with the front vertical mounting rails on the rack.
Figure 35: Moving a Cisco Nexus 7010 Chassis onto a Rack
Rack vertical mounting rails3Push the lower half of the front side of the chassis1
Chassis mounting brackets2
Step 4 Make sure that the screw holes in the chassis mounting brackets align with the screw holes in the vertical mounting rails.
If you need to reposition the chassis to align the screw holes, you can use the handles on the sides of the chassis.
To adjust the placement of the chassis so that the screw holes in the chassis mounting brackets align with the
screw holes in the vertical mounting rails, use the chassis handles shown in Figure 36: Attaching the Cisco
Nexus 7010 Chassis to the Rack, on page 79.
Tip
Step 5 Use a Phillips screwdriver to screw in four M6 x 19-mm or 12-24 x 3/4-inch screws in each of the two chassis mounting
brackets (use a total of eight screws for two mounting brackets) as shown in Figure 36: Attaching the Cisco Nexus 7010
Chassis to the Rack, on page 79.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
78
Installing a Cisco Nexus 7010 Chassis
Installing the Chassis
To Next Page
Loading...
