2. For each of the two front doors, match the two alignment pins on the door frame to the alignment holes
on the chassis. Position each door frame immediately under the cable management area (see Figure 44:
Installing the Front Doors, on page 88).
3. Tighten three screws for each door frame (see Figure 45: Attaching the Door Frames to the Chassis, on
page 89).
DETAILED STEPS
Step 1 Align the bottom frame assembly so that its four screw holes align to screw holes in the bottom of the chassis, and then
screw in four M4 x 6 mm screws to attach the bottom frame to the chassis (see Figure 43: Installing the Bottom Frame,
on page 87).
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
86
Installing a Cisco Nexus 7010 Chassis
Installing the Front Doors and Frame Assembly
To Next Page