Cisco Nexus 9508 - CHAPTER 5 Managing the Switch; Displaying Information About the Installed Hardware Modules

CHAPTER 5
Managing the Switch
•
Displaying Information About the Installed Hardware Modules, page 47
•
Displaying the Hardware Inventory for a Switch, page 51
•
Displaying the Backplane and Serial Number Information, page 51
•
Displaying Environmental Information for the Switch, page 53
•
Displaying the Current State of a Module, page 54
•
Displaying Temperatures for a Module, page 56
•
Connecting to a Module, page 58
•
Saving the Module Configuration, page 59
•
Shutting Down or Starting Up a Module, page 59
•
Purging a Nonfunctioning Module from the Running Configuration, page 60
•
Displaying Power Usage Information, page 60
•
Power Cycling a Module, page 61
•
Rebooting a Switch, page 62
•
Overview of Supervisor Modules, page 63
•
Overview of Line Card Support, page 65
•
Overview of Fabric Modules, page 66
•
Overview of Power Modes, page 68
•
Overview of Fan Trays, page 73
Displaying Information About the Installed Hardware Modules
You can display information about the switch hardware and the hardware modules installed in the switch
chassis by using the show hardware command.
switch# show hardware
Cisco Nexus Operating System (NX-OS) Software
TAC support: http://www.cisco.com/tac
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
47