Cisco Nexus 9508 - Overview of Line Card Support

DescriptionUsageModule Terms
•
sup-active refers to the active supervisor
module—relative to the slot that contains the active
supervisor module.
•
sup-standby refers to the standby supervisor
module—relative to the slot that contains the standby
supervisor module.
Relativesup-active and sup-standby
If you are logged into the active supervisor, the following
applies:
•
sup-local refers to the active supervisor module.
•
sup-remote refers to the standby supervisor module.
If you are logged into the standby supervisor, the following
applies:
•
sup-local refers to the standby supervisor module (the
one that you are logged into).
•
There is no sup-remote available from the standby
supervisor module (you cannot access a file system on
the active supervisor).
Relativesup-local and sup-remote
Overview of Line Card Support
The switch supports the following line cards in slots LC1 through LC8 depending on the type of installed
fabric module:
•
Line cards supported by N9K-C9508-FM fabric modules
◦
8-port 100-Gigabit Ethernet QSFP+ line card (N9K-X9408PC-CFP2)
◦
32-port 40-Gigabit Ethernet QSFP+ line card (N9K-X9432PQ) supporting 1 x 40, 1 x 10, and 1 x
1 Gigabit Ethernet
◦
36-port 40-Gigabit Ethernet QSFP+ aggregation (non-blocking) line card (N9K-X9636PQ)
◦
36-port 40-Gigabit Ethernet QSFP+ line card (N9K-X9536PQ)
◦
48-port 1/10-Gigabit Ethernet SFP+ and 4-port 40-Gigabit Ethernet QSFP+ line card
(N9K-X9464PX)
◦
48-port 1/10-GBASE-T and 4-port 10/40-Gigabit Ethernet QSFP+ line card (N9K-X9464TX)
◦
48-port 1/10-GBASE-T and 4-port 10/40-Gigabit Ethernet QSFP+ line card (N9K-X9464TX2)
◦
48-port 1/10-Gigabit Ethernet SFP+ and 4-port 40-Gigabit Ethernet QSFP+ line card
(N9K-X9564PX)
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
65
Managing the Switch
Overview of Line Card Support