Cisco Nexus 9508 - System Controller LEDs

StatusColorLED
Line cards (I/O modules) are all operational.GreenIOM
Check the Line Card LEDs, on page 130 for more information.Amber
Power supplies are all operational.GreenPSU
Check the Power Supply LEDs for more information.Amber
Fan trays are all operational.GreenFAN
Check the Fan Tray LEDs for more information.Amber
Sufficient power is available for all of the installed modules.GreenPWR
MGMT
Either of the following:
•
Insufficient power for at least one of the installed modules.
•
The configured power redundancy mode differs from the operational power
redundancy.
Amber
System Controller LEDs
The system controller module LEDs are located on the left side of the module. The following table describes
the possible states for each of these LEDs.
StatusColorLED
The operator has activated this LED to identify this module in the chassis.Flashing blueBCN
This module is not being identified.Off
This module is operational.GreenSTS
This module is booting up.Flashing
amber
Temperature exceeds major alarm threshold.Flashing red
The module is not receiving power.Off
The controller module is operational and in active mode.GreenACT
The controller module is operational and in standby mode.Amber
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
128
LEDs
System Controller LEDs