Removing a Fabric Module
Before You Begin
•
You must wear an electrostatic discharge (ESD) wrist strap or other ESD protective device while handling
modules.
•
Prepare an antistatic surface or packing materials for each module that you remove from the chassis.
•
You must remove the fan tray that covers the fabric module that you are removing.
Step 1
If you are replacing a fabric module, open the packaging for the new module and inspect it for damage.
If the module is damaged, alert the Technical Assistance Center (TAC) and stop this replacement process until you have
an undamaged module to install.
Step 2
Remove the fan tray that covers the fabric module by following these steps:
a) Unscrew the four captive screws on the front of the fan tray until each screw is free of the chassis (see Callout 1 in
the following figure).
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
93
Replacing or Installing Modules, Fan Trays, and Power Supplies
Removing a Fabric Module
To Next Page
Loading...
