Cisco Nexus 9508 - Rebooting a Switch

To see which slots are filled with modules, use the show inventory command.Note
These commands report on only software-controlled modules, such as supervisors, system controllers,
line cards, fabric modules, fan trays, and power supplies. They do not report on modules that are not
controlled by software, such as blank modules installed in empty slots to control airflow.
Note
Step 1
Use the configure terminal command to enter the global configuration mode.
Example:
switch# configure terminal
switch(config)#
Step 2
Use the reload module slot_number command to specify the slot number of the module to reset.
Example:
switch(config)# reload module 4
This command will reload module 4. Proceed[y/n]? [n] y
reloading module 4 ...
switch(config)#
Rebooting a Switch
You can reboot or reload the switch by using the reload command without any options.
If you need to use the reload command, be sure to save the running configuration first by using the copy
running-config startup-config command.
Note
Step 1
Use the configure terminal command to enter the global configuration mode.
Example:
switch# configure terminal
switch(config)#
Step 2
Use the copy running-config startup-config command to save the running configuration.
Example:
switch(config)# copy running-config startup-config
Step 3
Use the reload command to reload the switch.
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
62
Managing the Switch
Rebooting a Switch