Cisco Nexus 9508 - Supervisor Module LEDs; Fan Tray LEDs

Supervisor Module LEDs
The Beacon (BCN), Status (STS), and Active (ACT) LEDs are located on the lower left front of the supervisor
module. The management port link and active LEDs are located immediately above the port on the front of
the module. The following table describes the possible states for each of these LEDs.
StatusColorLED
The operator has activated this LED to identify this module in the chassis.Flashing blueBCN
This module is not being identified.Off
This module is operational.GreenSTS
This module is booting up.Flashing
amber
Temperature exceeds major alarm threshold.Flashing red
The module is not receiving power.Off
This module is operational and in active mode.GreenACT
This module is operational and in standby mode.Amber
The management port is linked up.Green(management
port LINK)
The management port is not linked up.Off
The module is transmitting or receiving.Flashing
green
(management
port ACT)
The module is not transmitting or receiving.Off
Fan Tray LEDs
The fan tray LEDs are located on the lower right portion of the module. The following table describes the
possible states indicated by this module.
StatusColorLED
The operator has activated this LED to identify this module in the chassis.BlueBCN
This module is not being identified.
Off
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
129
LEDs
Supervisor Module LEDs