Cisco Nexus 9508 - Displaying Temperatures for a Module

27 0 Supervisor Module N9K-SUP-A active *
28 0 Supervisor Module N9K-SUP-A ha-standby
29 0 System Controller N9K-SC-A active
30 0 System Controller N9K-SC-A standby
Mod Power-Status Reason
--- ------------ ---------------------------
24 powered-dn Configured Power down
26 powered-dn Configured Power down
Mod Sw Hw
--- -------------- ------
4 6.1(4.11) 0.1010
22 6.1(4.11) 0.1010
27 6.1(4.11) 0.3011
28 6.1(4.11) 1.0
29 6.1(4.11) 0.2010
30 6.1(4.11) 0.2010
Mod MAC-Address(es) Serial-Num
--- -------------------------------------- ----------
4 00-22-bd-f8-2a-83 to 00-22-bd-f8-2a-b6 SAL17257AHD
22 00-00-00-00-00-00 to 00-00-00-00-00-00 SAL17194HVX
24 00-00-00-00-00-00 to 00-00-00-00-00-00 SAL17194HRK
26 00-00-00-00-00-00 to 00-00-00-00-00-00 SAL17194HSR
27 00-22-bd-f6-9d-58 to 00-22-bd-f6-9d-69 SAL17184072
28 00-22-bd-fc-04-b0 to 00-22-bd-fc-04-c1 SAL1739DAUL
29 00-00-00-00-00-00 to 00-00-00-00-00-00 SAL17225YFS
30 00-00-00-00-00-00 to 00-00-00-00-00-00 SAL17225YG8
* this terminal session
switch#
This example shows how to display information about a module in a specific slot (slot 4) of the chassis.Note
switch# show module 4
Mod Ports Module-Type Model Status
--- ----- ----------------------------------- ------------------ ----------
4 36 36p 40G Ethernet Module N9k-X9636PQ ok
Mod Sw Hw
--- -------------- ------
4 6.1(4.11) 0.1010
Mod MAC-Address(es) Serial-Num
--- -------------------------------------- ----------
4 00-22-bd-f8-2a-83 to 00-22-bd-f8-2a-b6 SAL17257AHD
switch#
Displaying Temperatures for a Module
You can display temperature readings for module temperature sensors by using the show environment
temperature command. Each system controller, supervisor, line card, and fabric module has temperature
sensors with two thresholds:
• Minor temperature threshold—When a minor threshold is exceeded, a minor alarm occurs and the
following actions occur for all four sensors:
◦
Displays system messages
◦
Sends Call Home alerts (if configured)
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
56
Managing the Switch
Displaying Temperatures for a Module