Cisco Nexus 9508 - Displaying the Current State of a Module

)
Total Power Capacity (based on configured mode) 3000.00 W
Total Power of all Inputs (cumulative) 3000.00 W
Total Power Output (actual draw) 517.00 W
Total Power Input (actual draw) 563.00 W
Total Power Allocated (budget) 1728.24 W
Total Power Available for additional modules 1271.76 W
Clock:
----------------------------------------------------------
Clock Model Hw Status
----------------------------------------------------------
Fan:
------------------------------------------------------
Fan Model Hw Status
------------------------------------------------------
Fan1(sys_fan1) N9K-C9508-FAN 0.5020 Ok
Fan2(sys_fan2) N9K-C9508-FAN 0.5020 Ok
Fan3(sys_fan3) N9K-C9508-FAN 0.5010 Ok
Fan_in_PS1 -- -- Ok
Fan_in_PS2 -- -- None
Fan_in_PS3 -- -- None
Fan_in_PS4 -- -- None
Fan_in_PS5 -- -- None
Fan_in_PS6 -- -- None
Fan_in_PS7 -- -- None
Fan_in_PS8 -- -- None
Fan Zone Speed: Zone 1: 0x0
Fan Air Filter : NotSupported
Temperature:
--------------------------------------------------------------------
Module Sensor MajorThresh MinorThres CurTemp Status
(Celsius) (Celsius) (Celsius)
--------------------------------------------------------------------
4 CPU 105 95 32 Ok
4 TD2-1 105 95 41 Ok
4 TD2-2 105 95 41 Ok
4 TD2-3 105 95 41 Ok
4 VRM-1 110 100 41 Ok
4 VRM-2 110 100 45 Ok
4 VRM-3 110 100 40 Ok
22 CPU 105 95 34 Ok
22 TD2-1 105 95 45 Ok
22 TD2-2 105 95 41 Ok
22 VRM-1 110 100 49 Ok
22 VRM-2 110 100 47 Ok
27 OUTLET 75 55 29 Ok
27 INLET 60 42 21 Ok
27 CPU 90 80 27 Ok
28 OUTLET 75 55 27 Ok
28 INLET 60 42 21 Ok
28 CPU 90 80 32 Ok
29 CPU 105 95 40 Ok
30 CPU 105 95 34 Ok
switch#
Displaying the Current State of a Module
You can display information about modules installed in the switch chassis by using the show module command.
This information includes module type, bootup status, MAC addresses, serial numbers, software versions,
and hardware versions. You can use this command in the following ways to display information about all of
the installed modules or a specific module:
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
54
Managing the Switch
Displaying the Current State of a Module