EasyManua.ls Logo

Cisco Nexus 9508 - Displaying Power Usage Information; Power Cycling a Module

Cisco Nexus 9508
152 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Use the show environment power command to display power usage information for the switch. The following
example shows the output for a 3-kW AC power supply.
switch# show environment power
Power Supply:
Voltage: 12 Volts
Power Actual Actual Total
Supply Model Output Input Capacity Status
(Watts ) (Watts ) (Watts )
------- ------------------- ---------- ---------- ---------- -------------
-
1 N9K-PAC-3000W-B 517 W 566 W 3000 W Ok
2 ------------ 0 W 0 W 0 W Absent
3 ------------ 0 W 0 W 0 W Absent
4 N9K-PAC-3000W 0 W 0 W 0 W Shutdown
5 ------------ 0 W 0 W 0 W Absent
6 ------------ 0 W 0 W 0 W Absent
7 ------------ 0 W 0 W 0 W Absent
8 ------------ 0 W 0 W 0 W Absent
Actual Power
Module Model Draw Allocated Status
(Watts ) (Watts )
------- ------------------- ----------- ----------- --------------
4 N9k-X9636PQ 177.00 W 399.60 W Powered-Up
22 N9K-C9508-FM 118.00 W 300.00 W Powered-Up
24 N9K-C9508-FM N/A 0.00 W Powered-Dn
26 N9K-C9508-FM N/A 0.00 W Powered-Dn
27 N9K-SUP-A 47.00 W 79.92 W Powered-Up
28 N9K-SUP-A 45.00 W 79.92 W Powered-Up
29 N9K-SC-A 12.00 W 60.00 W Powered-Up
30 N9K-SC-A 23.00 W 60.00 W Powered-Up
fan1 N9K-C9508-FAN 47 W 225.00 W Powered-Up
fan2 N9K-C9508-FAN 48 W 225.00 W Powered-Up
fan3 N9K-C9508-FAN 47 W 249.00 W Powered-Up
N/A - Per module power not available
Power Usage Summary:
--------------------
Power Supply redundancy mode (configured) Non-Redundant(combined
)
Power Supply redundancy mode (operational) Non-Redundant(combined
)
Total Power Capacity (based on configured mode) 3000.00 W
Total Power of all Inputs (cumulative) 3000.00 W
Total Power Output (actual draw) 517.00 W
Total Power Input (actual draw) 566.00 W
Total Power Allocated (budget) 1728.24 W
Total Power Available for additional modules 1271.76 W
switch#
Power Cycling a Module
You can reset a module by using the reload module slot_number command and specifying the module by its
slot number in the chassis.
Reloading a module disrupts traffic through the module.Caution
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
61
Managing the Switch
Power Cycling a Module

Table of Contents

Related product manuals