Slide the module all the way into the chassis.3Slide the middle handle on the ejector lever to the
end of the lever and rotate the lever away from the
module.
1
Align the back of the module to the open slot in the
chassis.
2
b) Hold the front of the module with one hand and place your other hand under the module to support it.
c) Align the back of the module to the guides in the open controller slot and slide the module all the way into the slot.
The module stops when its front is about 0.25 inches (0.6 cm) outside the front of the chassis.
d) Rotate the ejector lever all the way to the front of the chassis until it locks in place with a click.
The module is fully seated on the midplane.
e) Screw in the two captive screws to secure the module to the chassis. Tighten each of these screws to 8 in-lb (0.9 N·m)
of torque.
f) Verify that the Status (STS) LED turns on and becomes green.
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
83
Replacing or Installing Modules, Fan Trays, and Power Supplies
Installing or Replacing a System Controller Module
To Next Page
Loading...
