VoltmeterTools/Equipment
Applicable procedures in Installing the ONS 15454 M6 Shelf, on page 1Prerequisite Procedures
RequiredRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Procedure
Step 1 If you installed an ONS 15454 M6, complete the following table by verifying that each applicable procedure
was completed.
Table 9: ONS 15454 M6 Shelf —ETSI Rack Installation Task Summary
CompletedDescription
NTP-G305 Unpack and Inspect the ONS 15454, ONS 15454 M2, and ONS 15454 M6 Shelves
NTP-G252 Install the ONS 15454 M6 Shelf , on page 24
Connect the chassis to the office ground. For detailed instructions on how to ground the chassis,
see the Electrostatic Discharge and Grounding Guide for Cisco CPT and Cisco ONS Platforms.
NTP-G259 Open and Remove the Standard Door of the ONS 15454 M6 Shelf , on page 57
NTP-G253 Install the ECU or ECU-S Module, on page 79
NTP-G524 Install the Power Modules in the ONS 15454 M6 Shelf , on page 85
NTP-G255 Install the LCD Module in the ONS 15454 M6 Shelf, on page 96
NTP-G256 Install Power and Ground to the ONS 15454 M6 Shelf , on page 100
NTP-G257 Install the Fan-Tray Assembly in the ONS 15454 M6 Shelf, on page 118
NTP-G313 Install and Configure the TNC, TNCE, TSC, or TSCE Card
NTP-G308 Connect the ONS 15454 M6 Multishelf Node and the ONS 15454 M6 Subtending
Shelves, on page 137 (as applicable)
NTP-G309 Connect the ONS 15454 M6 and the ONS 15454 in a Mixed Multishelf Configuration,
on page 139 (as applicable)
NTP-G310 Upgrade the ONS 15454 Multishelf Configuration Using the ONS 15454 M6 , on
page 149 (as applicable)
NTP-G298 Configure a Cisco Catalyst 2950 or Catalyst 3560 (Active and Standby) for a ONS
15454 Multishelf Node (as applicable)
NTP-G258 Install the Standard Door of the ONS 15454 M6 Shelf , on page 53
Installing the ONS 15454 M6 Shelf
156
Installing the ONS 15454 M6 Shelf
NTP-G264 Perform the ONS 15454 M6 Shelf Installation Acceptance Test
To Next Page
Loading...