Cisco SFE2000P

Contents
v
Cisco SCE 2000 4xGBE Installation and Configuration Guide
OL-7824-06
How to Power Down an AC-Input Power Supply 4-17
What to Do Next 4-18
How to Power Down a DC-Input Power Supply Unit and Remove the DC-Input Leads 4-18
What to Do Next 4-19
How to Remove the Power Supply Unit 4-19
How to Replace the Power Supply Unit 4-19
Reconnecting the Power 4-20
How to Reconnect AC-Input Power Supply Unit 4-20
How to Reconnect DC-Input Power Supply Unit 4-21
Fan Module Overview 4-23
Removing and Replacing the Fan Module 4-24
How to Remove the Fan Module 4-24
Replacing the Fan Module 4-25
How to Replace the Battery 4-26
CHAPTER 5 Connecting the Management Interfaces and Performing Initial System Configuration 5-1
How to Set Up the Local Console 5-1
Initial System Configuration 5-3
Setup Command Parameters 5-4
Step 1: How to Configure Initial Settings 5-6
Step 2: How to Configure the Hostname 5-7
Step 3: How to Set the Passwords 5-7
Step 4: How to Configure Time Settings 5-9
Step 5: How to Configure the DNS Settings 5-11
Step 6: How to Configure the RDR Formatter Destination 5-12
Step 7: Configuring Access Control Lists (ACLs) 5-12
How to Configure Access Control Lists (ACLs) 5-13
Step 8: How to Configure SNMP 5-17
Step 9: How to Configure the Topology-Dependent Parameters 5-19
Step 10: How to Complete and Save the Configuration 5-23
Connecting the Management Interface 5-25
How to Cable the Management Port 5-25
How to Verify Management Interface Connectivity 5-26
CHAPTER 6 Cabling the Line Ports and Completing the Installation 6-1
Connecting the line ports to the network 6-1
Cabling Diagrams 6-1
Single Link: Inline Topology 6-2
Single Link: Receive-only Topology 6-2