Cisco SG220-26P Administration Guide

10
Cisco 220 Series Smart Switches Administration Guide Release 1.1.0.x 123
Power over Ethernet
The Power over Ethernet (PoE) feature is only available on PoE-based models. For
a list of PoE-based models, refer to the Device Models section.
This chapter describes how to use the PoE feature and includes the following
topics:
• PoE Considerations
• PoE on the Switch
• Configuring PoE Properties
• Configuring PoE Port Settings
PoE Considerations
!
CAUTION The switch should be connected only to PoE networks without routing to the
outside plant.
Model Power Dedicated
to PoE
PoE Ports PoE Standard Supported
SF220-24P 180 Watts 1 to 24 802.3at
SF220-26P 180 Watts 1 to 24 802.3at
SF220-48P 375 Watts 1 to 48 802.3at
SG220-50P 375 Watts 1 to 48 802.3at
SF220-28MP 375 Watts 1 to 24 802.3at

Cisco SG220-26P Specifications

General

Model	SG220-26P
Ports	26
PoE Ports	24
Switching Capacity	52 Gbps
Forwarding Rate	38.69 Mpps
Layer	Layer 2
Power Supply	Internal
VLANs Supported	256
Management	Web-based GUI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-4°F to 158°F (-20°C to 70°C)
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 95% non-condensing
Dimensions	440 x 44 x 257 mm
Weight	3.3 kg